Making a Fedora 22 SD card for Wandboard
Wandboard has been under experimental support for Fedora 20, 21 and 22 (which is the latest at the time of writing).
This article describes how to make a Fedora SD card bootable on all Wandb
How to make a Fedora 22 SD card
The official instructions are at https://fedoraproject.org/wiki/Architectures/ARM/F22/Installation
Applying the official instructions is a little inconvenient since the SD cards are made using a Fedora-only tool (which means, you need to run Fedora on your desktop to make the SD cards).
At the time of writing, a general SD card snapshot image is located at http://ftp.yzu.edu.tw/Linux/Fedora/linux/releases/test/22_Beta/Images/armhfp/Fedora-KDE-armhfp-22_Beta-3-sda.raw.xz
Prepare an SD card using the Fedora tool or make it from the snapshot link above.
Step 2. (optional)
By default Fedora has pre-compiled u-boots for the WB Solo, Dual and Quad.
Many users are probably fine with that, so the rest of step 2 are optional.
Step 2a (optional)
In order to make an SD card that boots for all WB variants, u-boot has to be replaced with the SPL u-boot supporting all board variants.
To do this, the SPL u-boot has to be patched with Fedora's distribution patches. These can be found in uboot-tools-2014.10-0.5.rc3.fc22.src.rpm, downloadable from http://arm.koji.fedoraproject.org/koji/buildinfo?buildID=245199
Step 2b (optional)
Clone the wandboard u-boot from https://github.com/wandboard-org/u-boot-fslc.git
Apply patches 0001 through 0007. Also apply an additional 8th patch from: http://wandboard.org/images/downloads/0008-wandboard-Add-Fedora-support.patch
Step 2c (optional)
After patching the SPL u-boot, compile it with the usual:
and install SPL and u-boot with
sudo dd if=SPL of=/dev/sdX bs=1k seek=1 oflag=dsync
sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=69 oflag=dsync